每100mm使用紧固螺丝安装导轨在无油漆的金属薄板上，确保在机柜或开放式机架内良好的机械稳定性和良好的机箱接地。
该金属薄板至少应为2.5毫米厚的和至少180毫米高的好一长边弯曲90度，至少每500mm该金属薄板少采用四个螺钉机械地固定到机柜或机架。对于机柜框架的紧固应采用自攻螺钉来完成已获得接地连接效果。对于水平安装可以采用铝制板，铝制板有良好的接地和并使相关产品稳固安装。
铝制板应该至少采用四个自攻螺钉固定在机柜内。铝制板上有凹槽使螺钉固定住高振动环境下运行的模件。
MAC 82A-AC-000-TM-D?DAP-1DA PNEUMATIC SOLENOID VALCE
2 MRC 315R ABEC1 ROLLER BEARINGS 75MMX160MM37MM NEW
ACCUDRIVE F060C-003-C179 SERVO SPEED REDUCED NEW
14 MAC PME-551BAAA PNEUMATIC SOLENOID COILS NEW
6 POUNDS PRECISION WATER SYSTEMS DISTILLER CHARCOAL
ALLEN-BRADLEY 889R-F6ECA-10 6-PIN SENSOR? CABLE
14 MAC PME-551BAAA PNEUMATIC SOLENOID COILS NEW
6 POUNDS PRECISION WATER SYSTEMS DISTILLER CHARCOAL
ALLEN-BRADLEY 889R-F6ECA-10 6-PIN SENSOR? CABLE
2 POWER-ONE MAP110-4004 SWITCHING POWER SUPPLIES NEW
SEALMASTER 3-315 3-15/16″ SET SCREW BEARING NEW
STRIPPIT 1/2″ PUNCHES & DIES,MIXED,.328 THRU .494″
31 KENNAMETAL TG-100 COLLETS,3/32″ THRU 1″
