热电偶与热电阻的安装方法
1、首先应测量好热电偶和热电阻法兰或者螺纹螺牙的尺寸,加工配套好法兰或者螺纹底座.
2、要根据法兰或者螺纹底座的尺寸,在需要测量的管道上开孔.
3、法兰或者螺牙座的焊接.把法兰座或者螺纹底座插入已开好孔内,把法兰座或者螺纹底座与被测量的管道焊接好.
4、把热电偶或热电阻用螺栓紧固或者螺纹旋进已焊接好的螺纹底座.
5、按照接线图将热电偶或热电阻的接线盒接好线,并与表盘上相对应的显示仪表连接.注意接线盒不可与被测介质管道的管壁相接触,保证接线盒内的温度不超过100℃范围.接线盒的出线孔应防因密封不良,水汽灰尘等沉积造成接线端子短路.
6、热电偶或热电阻安装的位置,应考虑检修和维护方便
Motorola ProLog 7308B-01 PL Counter/Timer Card STDbus
Motorola ProLog 7507 I/O Rack Interface PCB VME
Motorola MCX100 Two-Way Mobile Trunk FM Radio
Force SYS68K/CPU-33B/4 VME Board CAT#: 510098 PN: 600-1
Force SYS68K/ISIO-1FP I/O Controller Dual Board w Cable
Motorola MVME202 MVME-202 Mainframe Board VME
Motorola MVME222-1 MVME 222-1 VME Mainframe Board VME
Motorola MVME2603 MVME-2603 VME Mainframe Processor
Motorola MVME332XTS MVME-332XTS 8-CH Intelligent Serial
Motorola MVME710B MVME-710B Adapter for 332XT, 8 CH VME
Motorola MVME935 MVME-935 Remote I/O Channel Connector
Motorola XVME-140 XVME140 Mainframe Board VME
EIS RTMS Remote Traffic Sensor X3 Radar Detector New
